Table of Contents
Advertisement
3) Tighten lateral rod nuts (1) to specified torque. It is the most
desirable to have vehicle off hoist and in non-loaded condi-
tion when tightening them.
Tightening torque
Lateral rod axle side nut (a): 50 N
Lateral rod body side nut (b): 100 N
Rear Shock Absorber Removal and Installa-
tion
REMOVAL
1) Hoist vehicle.
2) Support rear axle (or axle housing) by using floor jack to pre-
vent it from lowering.
3) Remove lower bolt (1).
4) Remove upper bolt (2) and nut (3). Then remove shock
absorber (4).
INSTALLATION
1) Install shock absorber (4) referring to figure.
Tighten bolt and nut temporarily at this step.
2) Remove floor jack from rear axle (or axle housing) and lower
hoist.
3) Tighten bolts and nut to specified torque.
Tightening torque
Rear shock absorber upper nut
·
(a): 63 N
m (6.3 kg-m, 45.5 lb-ft)
Rear shock absorber lower bolt
·
(b): 63 N
m (6.3 kg-m, 45.5 lb-ft)
A: Vehicle inside
Coil Spring Removal and Installation
REMOVAL
1) Hoist vehicle and remove rear wheel referring to "Wheel
Removal and Installation" in Section 3F.
2) Support rear axle (or axle housing) (1) by using floor jack (2)
to prevent it from lowering.
REAR SUSPENSION 3E-9
·
m (5.0 kg-m, 36.5 lb-ft)
·
m (10.0 kg-m, 72.5 lb-ft)
Advertisement
Table of Contents
