Suzuki Ignis Service Manual page 2708

(b)
(a)
ENGINE AND EMISSION CONTROL SYSTEM (Z13DT ENGINE) 6E3-49
Installation
Reverse removal procedure for installation noting the followings.
• Clean mating surfaces of crankcase ventilation cover and
cylinder block.
• Use new crankcase ventilation cover gaskets and ventilation
hose clamps.
• Tighten crankcase ventilation cover mounting bolts, oil sepa-
rator mounting bolts and generator bracket mounting bolts to
specified torque.
Tightening torque
Crankcase ventilation cover mounting bolt
(a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
Oil separator mounting bolt
(b): 15 N·m (1.5 kg-m, 10.8 lb-ft)
Generator bracket mounting bolt
(c): 25 N·m (2.5 kg-m, 18.0 lb-ft)
(c)
• Install generator referring to "Generator Dismounting and
Remounting" in Section 6H3.
• Install EGR valve assembly referring to "EGR valve assem-
bly removal and installation" in this section.
• Install air cleaner assembly referring to "Air Cleaner Assem-
bly Removal and Installation" in Section 6A3.