Table of Contents
Advertisement
3D-10 FRONT SUSPENSION
Stabilizer Bar and Bushings Component
1. Split pin
2. Stabilizer bar nut
3. Washer
4. Bushing
5. Control arm
6. Stabilizer bar
7. Mount bushing
8. Mount bracket:
Oblong hole side comes to the rear.
Stabilizer Bar and Bushings Removal and
Installation
REMOVAL
9. Stabilizer bar mounting bracket bolt
10. Paint mark
11. Paint mark (RH side)
1) Hoist vehicle and allow front suspension control arms to
hang free.
2) Remove front wheels, referring to "Wheel Removal and
Installation" in Section 3F.
3) Remove stabilizer bar split pins (3), nuts (1) and washers
(2).
Tightening torque
Do not reuse.
Advertisement
Table of Contents
