Table of Contents
Advertisement
5C-6 PARKING AND REAR BRAKE
9) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (b): 95 N·m (9.5 kg-m, 69.0 lb-ft)
10) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
Brake Drum Removal and Installation (for
4WD Model)
REMOVAL
1) Hoist vehicle and remove wheel referring to "Wheel Removal
and Installation" in Section 3F.
2) Remove brake drum screw (1) and release parking brake
lever.
3) Remove brake drum.
If brake drum can not be removed easily, increase clearance
between brake shoes and drum, referring to step a) – d) in
"Brake Drum Removal and Installation (for 2WD Model)".
a) Pull brake drum off by using 8 mm bolts (1).
NOTE:
When drum is removed, visually inspect wheel cylinder
for brake fluid leakage. Correct leaky point, if any.
INSTALLATION
1) Before installing brake drum, check outer diameter "a" of
brake shoes. If it is not within value as specified below,
adjust it to specification by turning adjuster.
Brake shoes
Measured brake
outer diameter
=
drum inside
"a"
diameter
2) Install brake drum after making sure that inside of brake
drum and brake shoes are free from dirt and oil.
0.5 to 1.0 mm
–
(0.02 to 0.04 in.)
Advertisement
Table of Contents
