Table of Contents
Advertisement
7A3-26 MANUAL TRANSAXLE (Z13DT ENGINE MODEL)
(A)
2
7) Remove snap ring (1) using special tool.
Special tool
(A): 09900-06107
1
8) Apply puller to 4th gear (2) and drive out 3rd & 4th gear hub
assembly (1) with 4th gear using hydraulic press.
CAUTION:
Make sure to use flat side of puller to avoid causing dam-
age to 4th gear tooth.
9) Remove 4th gear needle bearing.
Assembly
1) Clean all components thoroughly, inspect them for any
abnormality and replace with new ones as necessary.
2) To ensure lubrication, air blow oil holes (1) and make sure
that they are free from any obstruction.
3) Install two pieces of needle bearings (1) for 4th gear onto
main shaft.
NOTE:
1
Align each slot (2) of needle bearings.
Advertisement
Table of Contents
