Suzuki Ignis Service Manual page 3319

6-118 ENGINE GENERAL INFORMATION AND DIAGNOSIS
Step
7 Check CKP Sensor.
1) Remove CKP sensor referring to "Crankshaft
position sensor (CKP sensor) removal and
installation" in Section 6E1.
2) Remove metal particles on end face of CKP
sensor, if any.
3) Connect CKP sensor connector.
4) Turn ignition switch to ON position.
5) Check voltage between "C63-30" wire terminal
of ECM connector and engine ground by pass-
ing magnetic substance (iron) (1) while keep-
ing approx. 1 mm (0.03 in.) gap with respect to
end face of CKP sensor. See Fig. 2.
Does voltage vary from low (0 – 1 V) to high (4 – 5
V) or from high to low?
8 Check signal rotor for the following. See Fig. 3.
• Damage
• No foreign material attached
Is it in good condition?
Action Yes
Go to Step 8.
Intermittent trouble or
faulty ECM.
Check for intermittent
referring to "Intermittent
and Poor Connection" in
Section 0A.
No
Replace CKP sensor.
Clean rotor teeth or
replace signal rotor.