Table of Contents
Advertisement
3) Install master cylinder to brake booster.
4) Torque master cylinder mounting nuts to specification.
Tightening torque
Cylinder mounting nut (a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
5) Connect hydraulic lines and torque flare nuts to specifica-
tion.
Tightening torque
Brake pipe flare nut (b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
6) Connect reservoir lead wire.
7) Fill reservoir with specified brake fluid up to MAX mark on it.
8) After installing, check brake pedal play and bleed air from
system.
9) Perform brake test and check each installed part for fluid
leakage.
Master Cylinder Removal and Installation (for
RH Model)
REMOVAL
1) Clean outside of master cylinder.
2) Drain brake fluid in reservoir.
3) Disconnect fluid level switch coupler (1) on reservoir.
4) Disconnect brake pipes (2) connected to master cylinder.
[A]: with ABS
[B]: without ABS
5) Remove master cylinder mounting nuts (3).
6) Remove master cylinder and master cylinder gasket.
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-15
Advertisement
Table of Contents
