Table of Contents
Advertisement
3E-26 REAR SUSPENSION
INSTALLATION
Install removed parts in reverse order of removal, noting the fol-
lowing points.
1) Install wheel bearing spacer (1) with the tapered side of its
inner diameter directed toward outside, or brake drum side.
2) Press in a new bearing (2) and retainer ring (3) in order by
using an hydraulic press (4).
NOTE:
Use care not to cause any damage to outside of retainer
ring.
A : Tapered side
B : Blank
C : Differential side
D : Without ABS
E : With ABS
3) Inspect axle shaft length.
Rear axle shaft length "a"
Left side: 792.0 mm (31.2 in.)
Right side: 673.0 mm (26.5 in.)
4) Apply grease to axle shaft oil seal (1) lip as shown.
"A": Grease 99000-25010
5) Apply sealant to mating surface of rear axle housing (2) with
brake back plate.
NOTE:
Make sure to remove old sealant before applying it anew.
"B": Sealant 99000-31090
Advertisement
Table of Contents
