Table of Contents
Advertisement
7A3-6 MANUAL TRANSAXLE (Z13DT ENGINE MODEL)
(A)
1
2
(1), "A"
Differential Side Oil Seal Replacement
1) Drain transaxle oil referring to "Manual Transaxle Oil
Change" in this section.
2) Remove front drive shafts referring to "Front Drive Shaft
Assembly Removal and Installation" in Section 4A.
3) Remove oil seals (1) using special tool.
Special tool
(A): 09913-58610
2. Extension case cover
(A)
4) Install new oil seals (1) using special tool and hammer.
NOTE:
When installing oil seal, face its spring side inward.
(A)
Special tool
(A): 09926-28610
5) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal contacts and make sure of its smooth-
ness.
"A": Grease 99000-25010
6) Install front drive shafts referring to "Front Drive Shaft
Assembly Removal and Installation" in Section 4A.
7) Fill transaxle oil as specified referring to "Manual Transaxle
Oil Change" in this section, and make sure that oil has been
sealed with oil seal.
Advertisement
Table of Contents
