Table of Contents
Advertisement
6A3-30 ENGINE MECHANICAL (Z13DT ENGINE)
2, (b)
(a)
Installation
1) Install clutch cover and clutch disc referring to "Clutch Cover,
1, (a)
Clutch Disc and Flywheel Removal and Installation" in Sec-
tion 7C3.
2) Connect transaxle to engine referring to "Transaxle Unit Dis-
mounting and Remounting" in Section 7A3.
3) Lift engine with transaxle into engine compartment, but do
not remove lifting device.
4) Install engine rear mounting bolts (1), engine left mounting
nuts (2) and engine right mounting bracket bolts (3).
Tighten these bolts and nuts to specified torque.
Tightening torque
Engine rear mounting bolt
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
Engine left mounting nut
(b): 55 N·m (5.5 kg-m, 40.0 lb-ft)
3, (c)
Engine right mounting bracket bolt
(c): 55 N·m (5.5 kg-m, 40.0 lb-ft)
5) Remove lifting device.
6) Connect right and left drive shaft joints to differential gear
referring to "Front Drive Shaft Assembly Removal and Instal-
lation" in Section 4A for RM413D or "Front Drive Shaft
Assembly Removal and Installation" in Section 4A2 for
RB413D.
7) Install stabilizer bar referring to "Stabilizer Bar and Bushings
Removal and Installation" in Section 3D.
8) Install exhaust No.1 pipe referring to "Exhaust Pipe Removal
and Installation" in Section 6K3.
9) For RM413D, install cross member (1).
Tighten cross member bolts to specified torque.
Tightening torque
Cross member bolt (a): 60 N·m (6.0 kg-m, 43.0 lb-ft)
10) Install A/C compressor to its bracket. (if equipped)
11) Adjust water pump and generator drive belt tension referring
to "Water Pump / Generator Drive Belt Tension Inspection"
in Section 6B3.
(a)
1
12) Connect hoses, cables and electric wires disconnected in
removal procedure.
13) Install inter cooler inlet hose and inter cooler outlet No.1 and
No.2 hoses referring to "Inter Cooler Components" in this
section.
14) Install air cleaner assembly referring to "Air Cleaner Assem-
bly Removal and Installation" in this section.
15) For RB413D, install battery tray with degassing tank.
16) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
17) Refill engine oil referring to "Engine Oil and Oil Filter
Replacement" in Section 0B.
Advertisement
Table of Contents
