Table of Contents
Advertisement
WARNING:
For vehicles equipped with a Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "System Components and Wiring Location View" under "Gen-
eral Description" in air bag system section in order to confirm whether you are performing service
on or near the air bag system components or wiring. Please observe all WARNINGS and "Service
Precautions" under "On-Vehicle Service" in air bag system section before performing service on or
around the air bag system components or wiring. Failure to follow WARNINGS could result in unin-
tentional activation of the system or could render the system inoperative. Either of these two condi-
tions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
CAUTION:
The engine of this vehicle requires the use of unleaded fuel only. Use of leaded and/or low lead fuel
can result in engine damage and reduce the effectiveness of the emission control system.
General Description ....................................... 6C-1
On-Vehicle Service......................................... 6C-2
Fuel System Components............................ 6C-2
Precautions .................................................. 6C-3
Fuel Lines Inspection ................................... 6C-4
Fuel Pipe Removal and Installation.............. 6C-4
Fuel Filler Cap Inspection ............................ 6C-5
Fuel Tank Inlet Valve Removal and
Installation .................................................... 6C-6
Fuel Tank Inlet Valve Inspection .................. 6C-7
The main components of the fuel system are fuel tank, fuel pump assembly (with fuel filter, fuel level gauge, fuel
pressure regulator and tank pressure control valve), fuel/vapor separator fuel feed line and fuel vapor line.
For the details of fuel flow and fuel vapor flow, refer to "General Description" in Section 6E1.
SECTION 6C
ENGINE FUEL
CONTENTS
Fuel Tank Removal and Installation............. 6C-7
Fuel Tank Inspection.................................. 6C-10
Fuel Tank Purging Procedure .................... 6C-10
Fuel Pump On-Vehicle Inspection ............. 6C-11
Fuel Pump Assembly Removal and
Installation.................................................. 6C-11
Fuel Pump Inspection ................................ 6C-12
Special Tool.................................................. 6C-13
Tightening Torque Specification ................ 6C-13
General Description
ENGINE FUEL 6C-1
6C
Advertisement
Table of Contents
