Table of Contents
Advertisement
3B-12 MANUAL RACK AND PINION
2
b) Install engine rear mount bracket.
"a"
"a"
d) Install exhaust pipe bracket.
3) Remove transmission jack.
4) Install tie rod ends to knuckles (right & left). Tighten each
5) Be sure that steering wheel and brake discs (right & left) are
Tightening torque
Engine rear mount bracket bolt
(a): 55 N·m (5.5 kg-m, 40 lb-ft)
c) Install propeller shaft to joint flange aligning match marks
(2) and tighten flange bolts to specified torque.
Tightening torque
Propeller shaft joint bolt (a): 23 N·m (2.3 kg-m, 16.6 lb-ft)
new tie rod end nut (1) to specified torque.
Tightening torque
Tie rod end nut (a): 40 N·m (4.0 kg-m, 29.0 lb-ft)
all straight-ahead position and then insert steering lower joint
into steering pinion shaft.
Advertisement
Table of Contents
