Table of Contents
Advertisement
2, (a)
1
(a)
1
MANUAL TRANSAXLE (Z13DT ENGINE MODEL) 7A3-31
4) Install differential assembly and then install differential bear-
ing retaining ring with specified procedure according to "Dif-
ferential Adjustment" in this section.
5) Install retaining ring lock plate (1) and then tighten lock plate
bolt (2) with specified torque.
Tightening torque
Lock plate bolt (a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
6) Install differential cover (1) and new gasket to transaxle
case.
Tightening torque
Differential cover bolt (a): 18 N·m (1.8 kg-m, 13.0 lb-ft)
7) Install left side oil seal referring to "Differential Side Oil Seal
Replacement" in this section.
8) Install differential side oil seal referring to "Differential Side
Oil Seal Replacement" in this section.
9) Install pinion needle bearing (1) to transaxle case using spe-
cial tools.
Special tool
(A): 09925-18620
10) Install main shaft roller bearing (2) to transaxle case using
special tools.
Special tool
(A): 09925-18620
Advertisement
Table of Contents
