ii) Insert cage into housing (1) and fit snap ring (2) into
groove of housing.
CAUTION:
Position opening of snap ring "c" so that it will not be
lined up with a ball.
iii) Set new differential side small band (2) and differential
side boot (1) on shaft temporarily.
12) Apply grease in the supplied parts to DOJ and inside of
housing.
Color
For right side shaft : Black and grey
For left side shaft : Black
Amount
For right side shaft : 75 – 95 g (2.7 – 3.4 oz)
For left side shaft : About 100 g (3.6 oz)
13) Place DOJ onto spline of drive shaft and drive onto drive
shaft by using plastic hammer until retaining ring engages.
FRONT DRIVE SHAFT 4A-13