Suzuki Ignis Service Manual page 2550

3
1
1, (a)
Inter Cooler Removal and Installation
Removal
1) Remove front bumper referring to "Front Bumper and Rear
Bumper Removal and Installation" for RM413D or "Front
Bumper and Rear Bumper" for RB413D in Section 9.
2) Remove horn (1) with its bracket (2) and radiator right side
2
bracket (3).
1
3) Disconnect inter cooler outlet No.1 hose (1) and inlet hose
2
(2) from inter cooler (3).
4) Remove inter cooler from vehicle.
3
Installation
Reverse removal procedure for installation noting the following.
• Tighten hose clamps (1) to specified torque.
Tightening torque
1, (a)
Inter cooler hose clamp (a): 3 N·m (0.3 kg-m, 2.5 lb-ft)
• Install front bumper referring to "Front Bumper and Rear
Bumper Removal and Installation" for RM413D or "Front
Bumper and Rear Bumper" for RB413D in Section 9.
ENGINE MECHANICAL (Z13DT ENGINE) 6A3-9