Suzuki Ignis Service Manual page 2639

6B3-16 ENGINE COOLING (Z13DT ENGINE)
Installation
1) Install drive belt (2) while turning tensioner (1) clockwise until
stopping.
2) Check drive belt tension referring to "Water Pump / Genera-
tor Drive Belt Tension Inspection" in this section.
Water Pump / Generator Drive Belt Tensioner
Assembly Removal and Installation
CAUTION:
Do not disassemble drive belt tensioner assembly. Dis-
assembly will spoil its original function. If any malcondi-
tion is found in drive belt tensioner assembly, replace it
as assembly.
Removal
1) Disconnect negative cable at battery.
2) Remove drive belt referring to "Water Pump / Generator
Drive Belt Removal and Installation" in this section.
3) Remove tensioner (1).
Installation
1) Install tensioner (1).
Tighten tensioner bolt (2) to specified torque.
Tightening torque
Tensioner bolt (a): 50 N·m (5.0 kg-m, 36.0 lb-ft)
2) Install drive belt referring to "Water Pump / Generator Drive
Belt Removal and Installation" in this section.
3) Check belt tension referring to "Water Pump / Generator
Drive Belt Tension Inspection" in this section.