Table of Contents
Advertisement
6C-12 ENGINE FUEL
2
3
4
4
(a)
1) Clean mating surfaces of fuel pump assembly (1) and fuel
tank.
2) Put plate (2) on fuel pump assembly (1) by matching the pro-
trusion of fuel pump assembly (3) to plate hole (4) as shown.
3
1
3) Install new gasket (2) and fuel pump assembly (1) with plate
(3) to fuel tank (4).
3
Tightening torque
1
Fuel pump assembly bolts (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
2
4
4) Connect fuel breather hose (1), fuel vapor hose (2) and fuel
feed line (3) (pipe joint) to fuel pump assembly (4).
5) Install fuel tank (1) to vehicle referring to "Fuel Tank
Removal and Installation" in this section.
Fuel Pump Inspection
• Check fuel pump assembly for damage.
• Check fuel suction filter (1) for evidence of dirt and contami-
nation.
If present, replace or clean and check for presence of dirt in
fuel tank.
• For electrical circuit, refer to "Table B-3 Fuel Pressure
Check" in Section 6.
• For inspection of fuel level gauge (2), refer to "Fuel Level
Sensor (Gauge Unit) Inspection" in Section 8C.
Advertisement
Table of Contents
