Table of Contents
Advertisement
Rear Wheel Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable from battery.
2) Hoist vehicle.
3) Disconnect rear wheel speed sensor coupler (1).
4) Detach ABS wheel sensor wire harness (2) from suspension
frame (3).
Do not detach clip of rear wheel speed sensor connector
from vehicle body unless replacement is necessary.
5) Remove rear wheel speed sensor (4) from rear axle housing.
CAUTION:
• Do not pull wire harness when removing rear wheel
speed sensor.
• Do not cause damage to surface of rear wheel speed
sensor and do not allow dust, etc. to enter its installa-
tion hole.
Installation
1) Check that no foreign material is attached to sensor (1) and
ring.
2) Reverse removal procedure for installation noting the follow-
ing.
• There is another bolt hole (2) that is fit for wheel speed sen-
sor bolt by proper bolt hole (3).
Be sure to install wheel speed sensor and its bolt at the cor-
rect (upper) position as shown in figure.
Tightening torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
(b): 2.5 N·m (0.25 kg-m, 1.8 lb-ft)
CAUTION:
Do not pull or twist wire harness more than necessary
when installing rear wheel speed sensor.
3) Check that there is no clearance between sensor and rear
axle shaft.
ANTILOCK BRAKE SYSTEM (ABS) 5E-39
Advertisement
Table of Contents
