Table of Contents
Advertisement
Bump Stopper / spring Upper Seat Check
• Inspect for cracks, deformation or damage.
Replace any defective part.
Rear Suspension Fasteners
Check each bolt and nut fastening suspension parts for tight-
ness.Tighten loose one, if any, to specified torque referring to the
figure in "Rear Suspension Construction" in this section.
Wheel Disc, Bolt and Bearing Check
• Inspect each wheel disc for dents, distortion and cracks.
A disc in badly damaged condition must be replaced.
• Check wheel bolts for tightness and, as necessary, retighten
to specification.
Tightening torque
Wheel bolt (a): 95 N · m (9.5 kg-m, 69.0 lb-ft)
• Check wheel bearings for wear. When measuring thrust
play, apply a dial gauge to axle shaft center.
When measurement exceeds limit, replace bearing.
Thrust play limit
"a": 0.1 mm (0.004 in.)
• By rotating wheel actually, check wheel bearing for noise
and smooth rotation. If it is defective, replace bearing.
REAR SUSPENSION 3E-7
Advertisement
Table of Contents
