Table of Contents
Advertisement
7A3-16 MANUAL TRANSAXLE (Z13DT ENGINE MODEL)
6
5
1
1
1, (a)
(a)
(b)
2
4
3
(A)
(A)
2
(b)
1
(a)
2) Assemble 5th gear hub assembly (hub (3), sleeve (1) and
keys (4)) as shown in figure.
2. chamfer
5. Synchronizer ring
6. 5th gear
3) Install needle bearing, 5th gear and synchronizer ring onto
main shaft.
Drive 5th gear assembly onto main shaft facing chamfer of
sleeve to extension case cover side, using special tool and
hammer.
Special tool
(A): 09913-70123
4) Install snap rings (2) and confirm that snap ring is installed in
groove securely.
Special tool
(A): 09900-06107
5) Install 5th gear selector fork and then tighten new bolts (1) to
specified torque.
Tightening torque
5th gear selector fork bolt (a): 22 N·m (2.2 kg-m, 16.0 lb-ft)
CAUTION:
Do not reuse 5th gear selector fork bolts (1). Be sure to
use new adhesive pre-coated bolts. Otherwise, bolts may
loosen.
6) Install extension case cover (1) with new gasket and then
tighten bolts to specified torque.
Tightening torque
Extension case cover bolt
(a): 29 N·m (2.9 kg-m, 21.0 lb-ft)
(b): 12 N·m (1.2 kg-m, 8.5 lb-ft)
Advertisement
Table of Contents
