4A-16 FRONT DRIVE SHAFT
3
2
(A)
4) Install wheel side boot on shaft, fill up boot inside with
grease and then fasten boot big band (1) by drawing hooks
(2) with plier (3) and engage hooks (4) in slot and window
(5).
CAUTION:
• Bend each boot band against forward rotation (A).
• Do not squeeze or distort boot when fastening it with
bands.
Distorted boot caused by squeezing air may reduce its
durability.
5) Place new wheel side small band (1) onto boot putting band
outer end (2) against forward rotation (3) as shown in figure.
6) Install wheel side small band (1), putting its lower edge
against projected end (4) of boot (3) so that clearance "a" is
provided as shown in figure.
"a"
2. Shaft
1
4
7) Fasten small band by using special tool.
NOTE:
"b"
• Small band must not come out of its installation sec-
tion.
• Be sure to caulk small band securely until complete
contact "b" is obtained.
Special tool
(A) : 09943-57010