Table of Contents
Advertisement
INSTALLATION (FOR REAR BRAKE)
Reverse brake flexible hose installation procedure, nothing the
followings.
• Install brake hose securely, making sure that there is no
faulty condition such as inclination of metal fitting (1) of hose
relative to bracket (2) of vehicle body.
• Install E-ring (3) securely, making sure that it does not
project from end face of bracket (2).
After installing E-ring (3), check to make sure that tip end of
ring is not open and that there is no clearance between
metal fitting of hose end bracket.
T: Top side
4. Side member
F: Front side
5. E-ring Insure direction
• Fill and maintain brake fluid level in reservoir.
• Bleed brake system. Refer to "Air Bleeding of Brake System"
in Section 5.
• Perform brake test and check each installed part for fluid
leakage.
• Install clamps properly referring to figure and tighten bolts.
• When installing hose, make sure that it has no twist or kink.
Master Cylinder Reservoir Removal and
Installation (for LH Model)
CAUTION:
Observe CAUTION at the beginning of On-Vehicle Ser-
vice.
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-9
Advertisement
Table of Contents
