Table of Contents
Advertisement
Rear Axle Housing Removal and Installation
(for 4WD Model)
REMOVAL
1) Hoist vehicle and remove rear wheels referring to "Wheel
Removal and Installation" in Section 3F.
2) Remove rear axle shafts (right & left) referring to Steps 2) –
9) of "Rear Axle Shaft and Wheel Bearing Removal and
Installation (for 4WD Model))" in this section.
3) Disconnect brake pipes (3) (right & left) from flexible hoses
(2) and remove E-rings (1).
4) Release wheel speed sensor clamps from axle housing (if
equipped with ABS).
5) Before removing propeller shaft, give match marks (1) on
joint flange and propeller shaft (2) as shown.
6) Remove propeller shaft.
7) For jobs hereafter, support rear axle housing by using floor
jack (1) under axle housing (2).
8) Remove differential carrier assembly.
9) Remove lateral rod (1).
REAR SUSPENSION 3E-29
Advertisement
Table of Contents
