Table of Contents
Advertisement
6E3-36 ENGINE AND EMISSION CONTROL SYSTEM (Z13DT ENGINE)
1
3
2
4) Install vacuum pump referring to "Vacuum pump removal
and installation" in this section.
5) Connect negative cable to battery.
6) Check fuel leakage referring to "Fuel leakage check" in this
section.
Fuel pressure regulator inspection
Check resistance between terminals of fuel pressure regulator.
If resistance is out of specification, replace fuel pressure regulator
referring to "Fuel pressure regulator removal and installation" in
this section.
Fuel pressure regulator resistance
2.07 – 2.53 Ω at 20°C, 68°F
Engine coolant temperature sensor (ECT sensor)
removal and installation
Removal
1) Disconnect negative cable at battery.
2) Drain cooling system.
3) Detach heater outlet pipe (1).
4) Disconnect ECT sensor connector.
5) Remove ECT sensor (2) from thermostat housing (3).
Advertisement
Table of Contents
