Table of Contents
Advertisement
"1"
"6"
"10"
"12"
"15"
"17"
"19"
"11"
"13"
"8"
"4"
"2"
1
1
10) Remove generator bracket (1) from cylinder block.
11) Remove crank ventilation cover from cylinder block referring
1
12) Remove piston and connecting rod referring to "Pistons, Pis-
13) Loosen crankcase bolt (M10) and crankcase bolt (M8) in
"3"
"7"
"14"
"20"
"18"
"16"
"9"
"5"
14) Remove lower crankcase (1) from cylinder block using spe-
Special tool
(A): 0921-96510
(A)
15) Remove crankshaft (1) and flywheel side crankshaft oil seal
2
16) Remove main bearings (3) and main bearing (with thrust
3
4
3
ENGINE MECHANICAL (Z13DT ENGINE) 6A3-73
to "Oil separator and crankcase ventilation cover removal and
installation" in Section 6E3.
ton Rings, Connecting Rods and Cylinder Removal and
Installation" in this section.
numerical order as shown in figure a little at a time, and
remove them.
cial tool.
(2) from cylinder block.
bearing) (4) from cylinder block and lower crankcase.
Advertisement
Table of Contents
