Table of Contents
Advertisement
4A-6 FRONT DRIVE SHAFT
[A] : 2WD model
[B] : 4WD model
1. Right side drive shaft assembly
2. Left side drive shaft assembly
3. Wheel side joint (constant velocity ball joint) :
Apply grease included in spare parts to ball
joint.
4. Ball joint boot big band
4-1. DOJ boot big band
5. Ball joint boot
5-1. DOJ boot
6. Ball joint boot small band
6-1. DOJ boot small band
7. Drive shaft for DOJ
[A]
[B]
8. Snap ring
9. Center shaft side joint
(Constant velocity DOJ joint) :
Apply grease included in spare parts to DOJ
joint.
10. Snap ring
11. Damper
12. Differential side joint (Constant velocity DOJ) :
Apply grease included in spare parts to DOJ
13. Snap ring
14. Retaining ring
15. Boot (Differential or transfer side)
16. Circlip
17. Boot small band
18. Snap ring
19. Wheel side joint (Constant velocity joint) :
Apply grease included in spare part to joint.
Front Drive Shaft Disassembly and Assembly
Disassembly
For 2WD vehicle
CAUTION:
Disassembly of wheel side joint is not allowed. If any
abnormality is found, replace it as assembly.
1) Remove differential side boot big band (1) as follows.
a) For boot big band without joint
i) Remove boot big band by tapping boot and band with
plastic hammer. If it is hard to remove boot big band, cut it
using a nipper or a iron saw with care not to damage DOJ
housing.
b) For boot big band with joint
i) Draw hooks of boot big band together and remove band.
[A] : For boot big band without joint
[B] : For boot big band with joint
20. Boot (Wheel side)
21. Boot big band
22. Differential side joint :
Apply grease included in spare part to joint.
23. Damper (RH)
24. Transfer side joint (RH) :
Apply grease included in spare part to joint.
25. Oil seal
26. Center bearing support circlip
27. Center bearing support
28. Center bearing
29. Snap ring
30. Center shaft
Do not reuse.
Advertisement
Table of Contents
