Suzuki Ignis Service Manual page 2699

6E3-40 ENGINE AND EMISSION CONTROL SYSTEM (Z13DT ENGINE)
2
2
Engine oil level switch removal and installation (If
equipped)
Removal
1) Disconnect negative cable at battery.
2) Remove oil pan referring to "Oil Pan Removal and Installa-
3) Remove clip (1).
4) Remove engine oil level switch (2) from oil pan.
1
Installation
1) Check O-ring (1) of engine oil level switch deformed or dam-
1
2) Install engine oil level switch (2) to oil pan.
3) Install clip (3) to engine oil level switch connector securely.
3
4) Install oil pan referring to "Oil Pan Removal and Installation"
5) Connect negative cable to battery.
6) Check to make sure that there is no engine oil leakage.
Engine oil level switch inspection (If equipped)
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Check for continuity between terminals of engine oil level
Engine oil level switch specification
When engine oil is filled up to specified level: Continuity
When engine oil is drained: No continuity
tion" in Section 6A3.
age.
If malfunction is found, replace engine oil level switch.
in Section 6A3.
switch.
If found defective, replace engine oil level switch.