Suzuki Ignis Service Manual page 3501

6B-16 ENGINE COOLING
2) Install water pump assembly (1) to cylinder block and tighten
bolts and nut to specified torque.
Tightening torque
Water pump bolts and nut (a) : 22 N·m (2.2 kg-m, 16.0 lb-ft)
3) Install water pump pulley.
4) Install water pump/generator drive belt referring to "Water
Pump/Generator Drive Belt Removal and Installation" in this
Section.
5) Install A/C compressor belt (if equipped) referring to "Com-
pressor Drive Belt Inspection and Adjustment" in Section 1B.
6) Refill cooling system referring to step 7) to 22) of "Cooling
System Flush and Refill" in this section.
7) Connect negative cable at battery.
8) Check each part for leakage.
Water Pump Inspection
CAUTION:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
• Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise,
replace it.
Engine Coolant Temperature Sensor (ECT
Sensor) Removal and Installation
Refer to "Engine coolant temperature sensor (ECT sensor)
removal and installation" in Section 6E1.
Engine Coolant Temperature Sensor (ECT
Sensor) Inspection
Refer to "Engine coolant temperature sensor (ECT sensor)
inspection" in Section 6E1.