Table of Contents
Advertisement
7) Connect tie rod end to steering knuckle, install new tie rod
end nut and tighten nut (1) to specified torque.
Tightening torque
The rod end nut (a): 40 N·m (4.0 kg-m, 29.0 lb-ft)
8) Install brake disc (2) and brake caliper (3).
9) Tighten brake disc screws (4) and brake caliper bolt to spec-
ified torque.
Tightening torque
Brake disc screw: 9 N·m (0.9 kg-m, 6.5 lb-ft)
Brake caliper bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
10) Depress foot brake pedal and hold it there.
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (a): 175 N·m (17.5 kg-m, 127.0 lb-ft)
CAUTION:
Never reuse drive shaft nut (1).
11) Caulk drive shaft nut (1) as shown.
Caulking specification "a": 0.5 mm (0.02 in.) or more
CAUTION:
Be careful while caulking nut so that no crack will occur
in caulked part of nut. Cracked nut must be replaced with
new one.
12) Tightening wheel bolts to specified torque.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
FRONT SUSPENSION 3D-15
Advertisement
Table of Contents
