Table of Contents
Advertisement
6G3-6 CRANKING SYSTEM (Z13DT ENGINE)
Starting Motor Dismounting and Remounting
1. Starting motor
2. Magnetic switch lead wire nut
Dismounting
1) Disconnect negative cable at battery.
2) Remove battery and battery tray, if necessary.
3) Pull out the rubber lid from transmission case for removing starting motor mount bolt.
4) Remove starting motor mount bolt (upper side).
NOTE:
Make sure that starting motor mount bolt (upper side) does not fall into transmission case.
5) Disconnect magnetic switch lead wire and battery cable from starting motor terminals.
6) Remove starting motor mount bolt (lower side).
7) Remove starting motor.
Remounting
Reverse the dismounting procedure noting the following.
• Make sure that starting motor mount bolt (upper side) does not fall into transmission case.
• Tighten starting motor mount bolts to specified torque.
Tightening torque
Starting motor mount bolt: 25 N·m (2.5 kg-m, 18.0 lb-ft)
Starting motor mount bolt
ON-Vehicle Service
4
25 N·m (2.5 kg-m)
3. Battery cable nut
4. Starting motor mount bolt
Tightening Torque Specification
Fastening part
4
25 N·m (2.5 kg-m)
Tightening torque
N•m
25
2
1
3
Tightening torque
kg-m
2.5
lb-ft
18.0
Advertisement
Table of Contents
