Table of Contents
Advertisement
6C3-16 ENGINE FUEL (Z13DT ENGINE)
5) Turning fuel filter fastener (1) counterclockwise, remove fuel
filter fastener (1) from fuel filter case (4) using special tool
and vise (5).
Special tool
(A): 09919-48610
6) Remove fuel filter cap (2) and fuel filter element (3).
Installation
Reverse removal procedure for installation noting the following.
• Be sure to replace fuel filter element and O-ring as new one.
• Clean fuel filter case as follows.
a) Place container under bleed screw, and drain fuel loosing
bleed screw.
b) Tighten bleed screw.
c) Remove fuel filter case.
d) Pour diesel substitute (kerdane, diltine or paraffin) into fuel
filter case.
e) Clean fuel filter case with brush.
f) Dry and wipe out fuel filter case.
• Tighten fuel filter fastener (1) to specified torque using spe-
cial tool and vise (2).
Special tool
(A): 09919-48610
Tightening torque
Fuel filter fastener
(a): 30 N·m (3.0 kg-m, 22.0 lb-ft)
• Bleed air in system referring to "Air Bleeding of Fuel System"
in this section.
• Start engine and check that there are no fuel leakage.
Advertisement
Table of Contents
