Suzuki Ignis Service Manual page 2640

Water Pump Removal and Installation
Removal
1) Drain coolant referring to "Cooling System Draining" in this
section.
2) Remove drive belt referring to "Water Pump / Generator
Drive Belt Removal and Installation" in this section.
3) Remove water pump assembly (1).
Installation
1) Install new O-ring (2) to water pump.
2) Install water pump assembly (1) to cylinder block and tighten
nuts to specified torque.
Tightening torque
Water pump nut (a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
3) Install drive belt referring to "Water Pump / Generator Drive
Belt Removal and Installation" in this Section.
4) Refill cooling system referring to "Cooling System Flush and
Refill" in this section.
5) Check each part for leakage.
Water Pump Inspection
CAUTION:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
• Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise,
replace it.
ENGINE COOLING (Z13DT ENGINE) 6B3-17