Table of Contents
Advertisement
6) Tighten steering shaft joint bolts (1) and (2) to specified
torque (Lower side first and then upper side).
Tightening torque
Steering shaft joint bolt (a): 28 N·m (2.8 kg-m, 20.5 lb-ft)
[A]: Power steering
[B]: Manual steering
7) Install both wheels and tighten wheel bolts to specified
torque.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
8) Lower hoist.
9) Check toe setting. Adjust as required (refer to "Front Wheel
Alignment Construction" in Section 3A).
10) Tighten both tie rod end lock nuts to specified torque.
Tightening torque
Tie rod end lock nut (a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
Unit Repair
Rack Boot / Tie Rod Removal and Installation
REMOVAL
1) Remove steering gear case referring to "Steering Gear Case
Removal and Installation" in this section.
2) For ease of adjustment after installation, make marking (1) of
tie rod end lock nut position of tie rod end thread.
3) Loosen tie rod end lock nut and remove tie rod end.
4) Remove boot band (2) and clip (1).
5) Remove boot from tie rod.
MANUAL RACK AND PINION 3B-13
Advertisement
Table of Contents
