Table of Contents
Advertisement
7A3-22 MANUAL TRANSAXLE (Z13DT ENGINE MODEL)
1
2
10) Install gear shift rod locking bushes using plastic hammer.
3
11) Engage 2nd, 3rd and 5th gear and install gear shift rod con-
1
2, (a)
12) Install 5th gear pawl (1) to extension bearing plate case (2)
3, (a)
2
1
13) Install 5th gear inner bearing ring to main shaft (1) using spe-
(A)
1
9) Install 3rd & 4th gear selector rod (1) and selector fork (2) in
the same manner as step 5).
3. Selector fork pin
nector (1) with specified torque.
2. Gear shift rod connector bolt
Tightening torque
Gear shift rod connector bolt (a): 7 N·m (0.7 kg-m, 5.0 lb-ft)
CAUTION:
Do not reuse gear shift rod connector bolt (2). Be sure to
use new adhesive pre-coated bolts. Otherwise, bolts may
loosen.
and tighten bolts to specified torque.
Tightening torque
5th gear pawl bolt (a): 7 N·m (0.7 kg-m, 5.0 lb-ft)
CAUTION:
Do not reuse 5th gear pawl bolt (3). Be sure to use new
adhesive pre-coat bolts. Otherwise, bolts may loosen.
cial tool.
Special tool
(A): 09913-84510
Advertisement
Table of Contents
