Suzuki Ignis Service Manual page 2882

a
a'
b b'
INSTALLATION
Reverse removal sequence to install cooling unit, noting the fol-
lowing points.
• If cooling unit or evaporator is replaced, pour 25 cc of refrig-
erating oil to compressor suction-side.
• Install uniformly the padding (1) to installation hole.
1
• Evacuate and charge system according to previously
described procedure.
• Adjust heater control cable, referring to "Heater Control
Lever Assembly Removal and Installation" in Section 1A.
• Enable air bag system, if equipped.
Cooling Unit (Evaporator) Inspection
• Clog of A/C evaporator fins
If any clogs are found, A/C evaporator fins should be
washed with water and should be dried with compressed air.
• A/C evaporator fins for leakage and breakage
If any defects are found, repair or replace A/C evaporator.
• A/C evaporator fittings for leakage
If any defects are found, repair or replace A/C evaporator.
Evaporator Thermistor (Evaporator Tempera-
ture Sensor) Removal and Installation
REMOVAL
1) Remove evaporator referring to "Cooling Unit (Evaporator)
Removal and Installation" in this section.
2) Remove evaporator thermistor.
INSTALLATION
Reverse removal sequence to install cooling unit, noting the fol-
lowing points.
Install Evaporator thermistor (Evaporator temperature sensor) (3)
1
to its original position. When its original position is not sure, install
to the center of evaporator referring to figure.
2
1. Cooling unit
2. Evaporator
a = a'
3
b = b'
AIR CONDITIONING (OPTIONAL) 1B-31