Table of Contents
Advertisement
"A"
"20"
"15"
"11"
"9"
"6"
"4"
"2"
"10"
"8"
"13"
"17"
"19"
5) Install crankshaft (1) to cylinder block.
1
6) Apply sealant to cylinder block (1) as shown in figure.
1
"A": Loctite 5900
"A"
7) Install lower crankcase to cylinder block.
"a"
"A"
8) Tighten crankcase bolts (M10) ("1" – "10") and crankcase
NOTE:
Tighten these bolts in numerical order as indicated in fig-
"18"
ure in this procedure.
"14"
a) Tighten crankcase bolts (M10) to 20 N·m (2.0 kg-m, 14.5 lb-
"7"
b) Retighten by turning crankcase bolts (M10) to 80°.
"1"
c) Tighten crankcase bolts (M8) to 30 N·m (3.0 kg-m, 22.0 lb-
Tightening torque
crankcase bolt (M10):
"3"
Tighten 20 N·m (2.0 kg-m, 14.5 lb-ft) and 80° by the speci-
fied procedure
"5"
crankcase bolt (M8):
Tighten 30 N·m (3.0 kg-m, 22.0 lb-ft) by the specified pro-
"12"
"16"
cedure
NOTE:
After tightening lower crankcase bolts, check to be sure
that crankshaft rotates smoothly.
ENGINE MECHANICAL (Z13DT ENGINE) 6A3-75
®
"a": 3.0 mm (0.118 in.)
bolts (M8) ("11" – "20") as follows.
ft).
ft).
Advertisement
Table of Contents
