Table of Contents
Advertisement
9) Install cap and tighten it to specified torque, then confirm the
length "A".
Tightening torque
Master cylinder cap (RH vehicle)
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
Cap installation position
"A": Less than 26 mm (1.02 in.)
CAUTION:
Whenever master cylinder is assembled, make sure all
the function of master cylinder assembly referring to
"Master Cylinder Assembly Inspection (for RH Model)".
Master Cylinder Assembly Inspection (for RH
Model)
1) Install radiator cap tester with special tool to master cylinder
port (1).
NOTE:
For without ABS vehicle, install special tool (B) to oppo-
site side port (2).
Special tool
(A): 09952-46010
(B): 09952-26020
2) Apply air and confirm that pressure is not applied.
3) Set master cylinder (1) on vise (3) and adjust "A" to be the
following.
Cap adjustment position
"A": 50 mm (1.97 in.)
4) Apply air with radiator cap tester, and confirm that 50 kPa
pressure is applied.
5) Perform same steps 1) – 4) for port (2).
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-19
Advertisement
Table of Contents
