Table of Contents
Advertisement
3E-24 REAR SUSPENSION
Rear Axle Shaft and Wheel Bearing Removal
and Installation (for 4WD Model)
REMOVAL
1) Hoist vehicle and remove rear wheel and brake drum screw.
2) Remove rear brake drum by using two 8 mm bolts (1). For
details referring " Brake Drum Removal and Installation (for
4WD Model)" to Section 5C.
3) Drain gear oil from rear axle housing by loosening drain plug
(1).
2. Filler and level plug
4) Remove brake shoe referring to "Brake Shoe Removal and
Installation" in Section 5C.
5) Remove parking brake cable from brake back plate.
6) Disconnect brake pipe (2) from wheel cylinder and put wheel
cylinder bleeder plug (3) cap onto pipe to prevent fluid from
spilling.
7) Remove wheel speed sensor (1) from axle housing (if
equipped with ABS).
8) Remove brake back plate bolts from axle housing.
9) Using special tools indicated, draw out axle shaft with brake
back plate.
Special tool
(A): 09942-15511
(B): 09943-17912
Advertisement
Table of Contents
