Suzuki Ignis Service Manual page 2888

INSTALLATION
Reverse removal procedure to install compressor noting the fol-
lowing instructions.
• If compressor is replaced, pour new compressor oil by refer-
ring to "Replenishing compressor oil" under "Operation Pro-
cedure for Refrigerant Charge" in this section.
• Evacuate and charge system by referring to "Recovery"
under "Operation Procedure for Refrigerant Charge" in this
section.
• Adjust drive belt tension by referring to "Compressor Drive
Belt Inspection and Adjustment" in this section.
Compressor Drive Belt Inspection and
Adjustment
INSPECTION
• Check compressor drive belt (6) for wear and cracks, and
replace as required.
• Check compressor drive belt (6) tension by measuring how
much it deflects when pushed at intermediate point between
tension pulley (2) and crank pulley (5) with about 100 N
(10 kg) force after crankshaft pulley 1 rotating.
If belt tension is without specification, adjust belt tension
referring to procedures below.
Compressor drive belt tension
"a": 3 – 5 mm (0.12 – 0.20 in.)
New compressor drive belt tension
"a": 2 – 4 mm (0.08 – 0.16 in.)
ADJUSTMENT
1) Loosen tension pulley nut (3).
2) Adjust belt tension by tighten or loosen tension pulley adjust-
ing bolt (4).
3) Tighten tension pulley nut (3).
4) Turn the crank pulley (5) 1 revolution, then check belt ten-
sion.
AIR CONDITIONING (OPTIONAL) 1B-37