Table of Contents
Advertisement
6A3-48 ENGINE MECHANICAL (Z13DT ENGINE)
1
1
(A)
3
1
2
3
7
1
2
2
1
4
2
Reassembly
6
4
5
6) Remove camshafts (1) and camshaft gears (2) from cam-
shaft housing as follows.
a) Lock camshaft timing sprocket (1) using special tool.
Special tool
(A): 09917-68221
b) Loosen camshaft gear bolt (2) of intake manifold side.
c) Loosen camshaft gear bolt (3) of exhaust manifold side.
d) Loosen camshaft timing sprocket bolt (4), and remove cam-
shaft timing sprocket (1).
e) Remove camshafts and camshaft gears.
1) Apply engine oil to sliding surface of each camshaft and
camshaft housing, and then install intake manifold side cam-
shaft (1) and exhaust manifold side camshaft (2) to camshaft
housing (3).
NOTE:
Be sure to differentiate intake side and exhaust side cam-
shafts by marks shown in figure.
4. "LH" mark
5. "RH" mark
6. Crankshaft pulley side
7. Flywheel side
Advertisement
Table of Contents
