Suzuki Ignis Service Manual page 3546

INSTALLATION
1) Install TP sensor (1) to throttle body.
Fit TP sensor to throttle body in such way that its holes (3)
are a little away from TP sensor screw holes (2) as shown in
figure and turn TP sensor clockwise so that those holes
align.
Tightening torque
TP sensor screw (a): 2.5 N·m (0.25 kg-m, 1.8 lb-ft)
2) Connect connector to TP sensor securely.
3) Connect battery negative cable to battery.
Engine coolant temperature sensor (ECT sensor)
removal and installation
REMOVAL
1) Disconnect battery negative cable at battery.
2) Drain coolant referring to "Cooling System Draining" in Sec-
tion 6B.
WARNING:
To help avoid danger of being burned, do not remove
radiator cap while engine and radiator are still hot.
Scalding fluid and steam can be blown out under pres-
sure if cap is taken off too soon.
3) Remove air intake pipe.
4) Disconnect connector from ECT sensor.
5) Remove ECT sensor (1) from thermostat case.
1
INSTALLATION
Reverse removal procedure noting the following:
• Clean mating surfaces of ECT sensor (1) and thermostat
case.
• Check O-ring for damage and replace if necessary.
1, (a) • Tighten ECT sensor (1) to specified torque.
Tightening torque
ECT sensor (a): 15 N·m (1.5 kg-m, 11.5 lb-ft)
• Connect connector to ECT sensor (1) securely.
• Refill coolant referring to "Cooling System Refill" in Section
6B.
ENGINE AND EMISSION CONTROL SYSTEM 6E1-29