Suzuki Ignis Service Manual page 2996

5) Remove caliper (1) with carrier.
NOTE:
Hang removed caliper with a wire hook or the like (3) so
as to prevent brake hose (4) from bending and twisting
excessively or being pulled.
Don't operate brake pedal with pads removed.
6) Pull brake disc (2) off by using two 8 mm bolts.
7) Pull out wheel hub (1) with special tools.
Special tool
(A): 09943-17912
(B): 09942-15511
CAUTION:
When wheel hub is removed, replace wheel bearing as a
set.
8) Disconnect tie rod end (2) from steering knuckle (1) with
puller.
9) Remove wheel speed sensor (1) from knuckle (if equipped
with ABS).
10) Loosen strut bracket nuts (1).
F: Forward
11) Remove ball joint bolt (3).
12) Remove strut bracket bolts from strut bracket and then steer-
ing knuckle (2).
FRONT SUSPENSION 3D-13