Table of Contents
Advertisement
(a)
1, (b)
Unit Repair Overhaul
5) After fitting oil pan to lower crankcase, run in securing bolts
and start tightening at the center: move wrench outward,
tightening one bolt at a time.
Tighten oil pan bolts and nuts to specified torque.
Tightening torque
Oil pan bolt and nut (a): 9 N·m (0.9 kg-m, 7.0 lb-ft)
6) Install new O-ring and drain plug (1) to oil pan.
Tighten drain plug to specified torque.
Tightening torque
Drain plug (b): 20 N·m (2.0 kg-m, 14.5 lb-ft)
7) Install transaxle stiffener referring to "Transaxle Unit Dis-
mounting and Remounting" in Section 7A3.
8) Install exhaust No.1 pipe referring to "Exhaust Pipe Removal
and Installation" in Section 6K3.
9) Connect oil level switch connector.
10) Install oil level gauge.
11) Refill engine with engine oil referring to "Engine Oil and Oil
Filter Replacement" in Section 0B.
12) Check to make sure that there is no engine oil leakage and
exhaust gas leakage at each connection.
Engine Assembly Removal and Installation
Removal
1) Relieve fuel pressure referring to "Fuel Pressure Relief Pro-
cedure" in Section 6E3.
2) Disconnect negative cable at battery.
3) Remove engine hood after disconnecting windshield washer
hose.
4) Drain coolant referring to "Cooling System Flush and Refill"
in Section 6B3.
5) For RB413D, remove battery tray with degassing tank.
6) Remove air cleaner assembly with MAF sensor assembly
referring to "Air Cleaner Assembly Removal and Installation"
in this section.
7) Remove inter cooler inlet hose and inter cooler outlet No.1
and No.2 hoses referring to "Inter Cooler Components" in
this section.
8) Disconnect the following cables from transaxle.
• Clutch cable
• Gear select control cable
• Gear shift control cable
ENGINE MECHANICAL (Z13DT ENGINE) 6A3-27
Advertisement
Table of Contents
