Volkswagen Passat 1995 Official Factory Repair Manual page 3836

Sliding/tilting roof with glass panel
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.60.2
Page 14 of 15
Cable drive, checking 0-
position
If you replace the cable drive, it
must be installed in the "0-
position" (glass panel closed).
- Connect cable drive wiring
harness connector to
sliding/tilting roof harness
connector.
- Operate switch -1- and
count revolutions of drive
pinion -2-: "0-position" of
cable drive is between end
switch-off points -A- and -B-.
- End switch-off point -B- is
obtained by turning drive
pinion clockwise and end
switch-off point -A- by
turning counter-clockwise.
-A- End switch-off point for tilt
function 2 revolutions to 0-
position.
-B- End switch-off point for tilt
function 8.25 revolutions to
0-position.
60-34
12/7/2004