Volkswagen Passat 1995 Official Factory Repair Manual page 3829

Sliding/tilting roof with glass panel
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.60.2
Glass panel for siding/tilting roof,
installing
Panel must be installed in 0-position (sunroof
closed).
0-position:
Pins -3- must line up with notches (arrow).
Locating hooks -4- must be locked in guide rails.
If not, adjust parallel alignment
- Place sliding/tilting roof from above and install
mounting screws for frame/panel.
- Slightly tighten screws (Torx T 25).
Notes:
When tightening Torx screws -1- be sure that
adjustment plate is properly located (adjustment
plate is an integral part of guide channels) .
Tighten screws after adjusting panel height to 6
Nm (53 in. lb).
Page 7 of 15
60-27
Page 60-31
12/7/2004