Volkswagen Passat 1995 Official Factory Repair Manual page 3811

Sliding/tilting roof
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.60.1
- Position panel from above and install screws
between sliding block and panel.
- Slightly tighten screws (Torx key T25).
Notes for installation:
When inserting Torx screws -1- note correct
position of adjustment plate -2-.
Guide pins -3- are located in the elongated holes
of the adjustment plate.
Tighten screws after glass panel height
adjustment (6 Nm). Glass panel height
adjustment Page 60-14
Page 9 of 20
.
12/7/2004
60-9