Volkswagen Passat 1995 Official Factory Repair Manual page 3698

Airbag system, On Board Diagnostic (OBD), vehicles from 10.94
Diagnostic Trouble Code (DTC) table
Notes:
All possible DTCs, which can be recognized by the Airbag Control Module -J234- and printed out by
the Scan Tool VAG1551 are listed below as a 5-digit DTC.
The DTC code is only shown in the print-out.
Before replacing components listed as faulty, always first check wiring and ground connections
according to the wiring diagram.
Check all connectors at the relay panel for good connection.
After completed repair, always interrogate DTC memory and then erase memory using Scan Tool
VAG1551.
The DTC table may contain the fault category.
VAG1551 printout
00000
No malfunction
recognized
00532
Supply voltage
(B+)
Signal too large
Signal too small
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.01.2
Possible cause
If "No malfunction recognized" is displayed, the OBD is finished.
Generator faulty
Wiring or connector to Airbag
Control Module -J234-
Battery discharged or faulty
Corrective action
- Check Generator
Electrical Wiring Diagrams, Troubleshooting
and Component Locations
- Check wiring and connector to control
module according to wiring diagram
- Charge battery or replace
Page 11 of 28
01-27
12/7/2004