Volkswagen Passat 1995 Official Factory Repair Manual page 3641

Steering
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
- Open hose clips and push boot back.
- Clamp steering gear with rack in a vice.
Note:
Use vice clamps, check vice clamps for impurities
e.g. metal filings or similar and thoroughly remove.
- Remove tie rod.
Installing
Installing tie rod without locking fluid D6.
Install in reverse order. Tightening torque: 70 Nm (52
ft lb)
Installing tie rods with locking fluid D6
If parts are reused, it is essential to clean any residue
of locking fluid off the threaded studs of the inner joint
or the thread tapped hole as described below.
Otherwise there is a danger of the thread being
damaged when being reinstalled or removed.
Page 78 of 99
48-78
12/7/2004