Volkswagen Passat 1995 Official Factory Repair Manual page 3639

Steering
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
- Carefully slide bushing with roller bearing onto the
valve body.
- Drive bushing into the housing far enough so that
the groove for the circlip is visible.
- Install circlip.
- Remove adhesive tape.
- Remove installation mandrel 3315/17.
- Install Torx screw into valve body and tighten to 35
Nm (26 ft lb).
- Thread in locking screw, tighten to 30 Nm (22 ft lb)
and crimp at corner points.
- Grease pressure piece with AOF 063 000 04.
- Install pressure piece, spring and washer in
housing.
- Install cover with adjusting screw. Adjust steering
gear after installation in vehicle.
Page 76 of 99
48-76
12/7/2004