Volkswagen Passat 1995 Official Factory Repair Manual page 3817

Sliding/tilting roof
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.60.1
Page 15 of 20
Cable drive, checking 0-
position
If the cable is replaced, the
cable drive must be installed in
the "0-position" (panel for
sliding/tilting roof closed).
- Operate switch -1- and
count revolutions of drive
pinion -2-: "0-position" of
cable drive is between end
switch-off points -A- and -B-.
End switch-off point is
obtained by turning drive
pinion clockwise. End
switch-off point -B- is
obtained by turning pinion
counter-clockwise.
-A- End switch-off point for tilt-
up function 2 turns to 0-
position.
-B- End switch-off point for
sliding function 9 turns to 0-
position.
60-15
12/7/2004